To use a NetWare network, it is necessary to perform the following procedures.

• 1 NetWare Print Service Settings (See "NetWare Print Service Settings.")

Specify the NetWare print service settings. (Optional equipment is required to print or send a fax from a computer. For the equipment needed, see "Optional Equipment and System Requirements.")
To specify the settings from the computer, use:

• NWADMIN or PCONSOLE (Novell software provided with NetWare)

• Canon utilities

• 2 Protocol Settings (See "Protocol Settings.")

Specify the protocol settings. To specify the settings, use:

• The machine's control panel

• The Remote UI (via a web browser)

• Canon utilities

• 3 Computer Settings for Printing/Sending a Fax (See "Setting Up a Computer for Printing/Sending a Fax.")

Specify the settings of each computer you use for printing or sending a fax. (Optional equipment is required to print or send a fax from a computer. For the equipment needed, see "Optional Equipment and System Requirements.")

• It is recommended that you consult the administrator for the network you are using when performing steps 1 and 2 above.

• To configure settings with software other than the control panel of the machine, NWADMIN, or PCONSOLE, TCP/IPv4 protocol must be supported by your network environment (IPv6 is not supported).

• If you are using the imagePASS, the ColorPASS, or the PS-GX, see the manual provided with the imagePASS, the ColorPASS, or the PS-GX.

• If you are using the imagePASS, the ColorPASS, or the PS-GX, some functions are not available with this machine. For details, see the manual provided with the imagePASS, the ColorPASS, or the PS-GX.

• Back To Top